Savage Single Shot Firearms > Savage 219 Single Shot Rifles

Used barrel on it's way!

<< < (2/2)

Garnett:
Thanks for the update.  Will you please post pictures of the repaired area as it appears from the welder, and then again after you complete the fitting?  I think this will be of great interest to our readers.  Good luck on your project.

50fps:
I got a little anxious and broke out the file and knocked down the excess on the sides and ejector lever slot. I still have to drill out the retaining pin hole for the ejector lever, which is my biggest concern, then work on the hook area for the hinge pin.

Garnett:
Thanks for the pictures.  Please share the finished project with us. 

50fps:
Well, it has been a while, but I finally got some time to work on this project. After spending a few hours filing a little and test fitting I finally got the welded-up area shaped to the point that the barrel fits great there is no slop, opens and closes nicely, barrel fits tight to the breech and the ejector works properly. Next step is to take it to the range and test fire it and then on to the refinishing.

Garnett:
Another barrel is saved!  Good luck at the range.

Navigation

[0] Message Index

[*] Previous page